Klarstein Eliana Manual De Instrucciones página 32

EN
32
To replace the LED light:
1. Remove the grease filter.
2. Use a tool or the hand to press
the spring splinter of both sides
of LED light to the inside, until the
light is pressed out (see figure
right).
3. Then slightly pull the light
connecting wire out, and
dismantle the terminal of the light
connecting wire (see figure right).
4. Replace the LED light with a
commercially available LED light
of the same type (1.5 W). Make
sure that you reconnect the LED
light correctly.
5. To insert the LED light, repeat
steps 1-3 (see figure below) in
reverse order.