Tabla De Contenido; Safety Warnings; How It Works - Marmitek PRO SYSTEM 200 Modo De Empleo

SAFETY WARNINGS

• To prevent short circuits, this product should only be used inside and only in
dry spaces. Do not expose the components to rain or moisture. Do not use
the product close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high tempera-
tures or bright light sources.
• In case of improper usage or if you have altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the
case of improper usage of the product or when the product is used for pur-
poses other than specified. Marmitek does not accept responsibility for addi-
tional damage other than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• Do not open the product: the device may contain live parts. The product
should only be repaired or serviced by a qualified expert.
• Only connect the adapter to the mains after checking whether the mains vol-
tage is the same as the values on the identification tags. Never connect an
adapter or power cord when it is damaged. In that case, contact your sup-
plier.
Table of contents
1. HOW IT WORKS _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3
2. CONNECTIONS _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4
3. INSTALLATION _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5
4. FREQUENTLY ASKED QUESTIONS_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6
5. TECHNICAL DATA_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7
6. COMPONENTS AVAILABLE_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7
INTRODUCTION
Congratulations on your purchase of the IR System Module 200™. This Module
is the main component of the IR Control Pro System™. With it you can extend
the IR (infrared) signals of remote controls. The IR Control Pro System™ makes it
possible to control A/V devices while these are in a closed cupboard or when your
A/V equipment is out of sight.
The IR Control Pro Sytem™ is a modular infrared extension system and the com-
ponents required are available individually. As a result, this system can be used
universally and is suitable for just about any situation.

1. HOW IT WORKS

Locate your A/V equipment in a closed cupboard, TV cabinet or even in another
room. The IR receiver must be installed in view of your own remote control. Stick
the IR LEDs onto the front panel of your A/V equipment and place the IR main
module out of sight. Point the remote control at the IR receiver in order to send
the appropriate command to the IR LEDs (via the IR main module). These will
then immediately pass this onto the A/V equipment.
IRCP System Module 200™ 3