Maintenance And Storage - Lanaform Bali Manual Del Usuario

ADDITIONAL INFORMATION RELATING TO THE USE OF ESSENTIAL OILS
• Before using essential oils, please check the harmful effects that use of these products may have on your health.
• Always choose quality essential oils that are pure, 100% natural and intended for diffusion. Use them in moderation and with care. Follow the instructions and warnings stated on the
packaging of the essential oils, in particular by ensuring that:
• Pregnant women, people with epilepsy, asthmatics and people suffering from allergies and those with heart problems or serious illnesses do not use essential oils.
• Essential oils should only used for periods not exceeding 10 minutes in a baby's room (under 3 years old) and only when the baby is not actually in the room.
• Make sure that children and minors do not play with and use the device.
• Just a few drops (3 to 4 drops at most) of essential oils are sufficient to ensure that the device works properly and the scent is being diffused. Excessive use of essential oils could damage
the device.
• First pour water into the reservoir before adding drops of essential oils.
• Lanaform® cannot be held liable in the event of accidental damage resulting from any use contrary to the instructions given in this manual.

MAINTENANCE AND STORAGE

If the water contains too much calcium and too much magnesium, it may deposit a "white powder" in the device. If this foam is deposited on the transducer (ceramic ring producing
ultrasounds, diagram 1, point 3), this will prevent the device from working properly.
we recommend:
1) Preferably using boiled and cooled water for each use,
2) Cleaning the reservoir every 2 days and cleaning the transducer every week,
3) Changing the water in the reservoir every 2 days,
4) Cleaning the device and making sure that all its parts are completely dry when it is not in use.
To clean the transducer:
1) Put 2 to 5 drops of vinegar on its surface and leave them there for 2 to 5 minutes.
2) Brush the foam off the surface with a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the reservoir of the base in clean water.
4) Do not use soap, solvent or spray cleaner to clean the transducer.
To clean the reservoir:
1) Clean the reservoir with water using a soft cloth and vinegar if there are foam or limescale deposits on the inside.
2) Rinse the reservoir in clean water.
Storage:
After cleaning and drying the device, store it in a dry, cool place out of the reach of children.
9
EN