Zero Moustique LDS16-40AD-RC Manual De Instrucciones página 24

spinner (#2) on the motor axis (#6) behind the blades (#3). Secure in place by
tightening the spinner (#2) counterclockwise.
- Place the front grille (#1) against the rear grille (#5) by aligning the alignment
mark on top of the grilles, closing them together by the hooks on the front grille
and the slots on the rear grille, gently pull the snapping lock pin (#19) out and
turn the front grille clockwise to lock it, the snapping lock pin (#19) should enter.
(See image 1)
Note : To remove the front grille, gently pull the snapping lock pin out while turning the
front grille counter-clockwise.
- Tighten the locking screw (#20) to secure the snapping lock pin (#19).
USE
This fan is equipped with 4 speeds, 3 breeze modes, a timer and a remote control. The
buttons on the fan control panel operate in the same way as the remote control.
BUTTON
This button is used to set
the timer in increments of
0.5 hours to a maximum of
7.5 hours. When the timer
runs out, the fan will
TIMER
automatically turn off.
FUNCTION
0.5H, 1H, 2H, 4H.
Example 1: 0.5H indicates that the timer will stop after 30 minutes.
Example 2: 0.5H and 2H indicate that the timer will stop after 2.5 hours.
Example 3: 0.5H, 1H, 2H, 2H and 4H indicate that the timer will stop
after 7.5h.
DISPLAY
SCREEN