Operation - MTD SMART RG 145 Manual De Instrucciones

Operating instructions for lawn tractors
Gear release lever for units
with automatic drive
Fig. 17a
The lever is situated on the left side
of the unit between the footboard
and rear wheel.
To push the mower when the
engine is switched off:
Press lever inwards, then pull

outwards and swivel to the rear.
The lever is engaged in front of
the holder.
To drive:
Push the lever to the left and

press in.
Transmission release for
machines with a hydrostatic
drive
Units with drive lever
Fig. 17b
The lever is situated on the rear
panel of the machine.
To push the mower when the
engine is switched off:
Pull out lever and press to the

right.
To drive:
Push the lever to the left and

press in.
Units with accelerator
Fig. 17c
The lever is situated on the left side
of the unit between the footboard
and rear wheel.
To push the mower when the
engine is switched off:
Pull out lever and press to the

right.
To drive:
Push the lever to the left and

press in.
Combination indicator
(depending on model)
Fig. 18
According to the model, the combi-
nation indicator can consist of the
following elements.
Oil pressure (1):
The indicator light is lit while the
engine is running, immediately
switch off engine and check oil
level. Where necessary, visit a
garage.
Clutch (2):
Indicator light comes on if the
clutch/brake pedal is not depressed
or the parking brake is not engaged
when the engine starts.
Cutter deck (3):
The indicator lamp lights up when
the cutters are not switched OFF
at engine start.
Battery charge indicator (4):
If the indicator light lights up when
the engine is running, this means
that the battery is not sufficiently
charged.
Where necessary, visit a garage.
Operating hour counter (5):
This shows the elapsed engine
hours when ignition is on.
Ampere meter (6):
This shows the charging current
from the generator to the battery.
Slow engine speed
= needle at the centre.
Fast engine speed
= needle always on the right (+).
Optional functions:
– When the ignition is switched on,
the battery voltage indicator is
indicated for a short period and
then the operating hours are indi-
cated.
The operating hours are always
counted except for when the igni-
tion key is in the "Stop" position
or when it is removed.
– Each time 50 operating hours
have elapsed (according to the
model), the oil change indicator
"CHG/OIL" appears in the display
for five minutes.
This message appears after the
next two hours of operation. See
the engine manual for oil change
intervals.
Light (depending on model)
Fig. 21
Switch on headlights
= Set switch to "ON".
Some models do not feature the
light switch.
The headlights are lit as long as the
engine is running or the ignition key
is set to the position (depending
on model).
Seat with adjusting lever
(depending on model)
Fig. 19
Pull the lever, and adjust the seat.

Operation

Follow the instructions in the
engine handbook!
Danger
Risk of injury
No person, especially children,
and/or animals should be allowed
to stand close to the mower while it
is in use.
They could be injured by stones or
similar objects that might be thrown
out. Children must never be allo
wed to operate the mower.
Be particularly careful when
mowing in reverse gear (mowers
with OCR switch).
There must be nobody in the wor
king area of the unit.
Never empty the grass catcher
attachment while the cutter deck is
running. While emptying the grass
catcher attachment, you or other
persons may be injured by ejected
clippings.
Take extra care with opening and
closing the grass catcher; there is a
risk of crushing.
When mowing on steep slopes,
there is a risk of the mower tipping
over and you could be injured as a
result.
Do not drive across the face of
a slope, but only straight up and
down. The mower should not be
driven on slopes with a maximum
incline greater than 20%. Do not
turn the mower round while you are
still on the slope.
English
-
-
13