Work And Safety Instructions; General Information; Mechanical System - Festo TP1410 Instrucciones De Utilizacion

5 Work and safety instructions

5.1 General information

•
Trainees should work with the components and systems only under the
supervision of an instructor.
•
Observe specifications included in the technical data for the individual
components, and in particular all safety instructions!
•
Wear your personal protective equipment (safety shoes) when working on the
circuits.
Radio interference
This class-A device is intended for industrial environments. The device may cause radio
interference in other environments.
Avoid operating this device at the same time as sensitive devices.

5.2 Mechanical system

• Switch off the power supply!
–
–
–
Rotating axis
Danger of hair or jewelry being pulled in
• Check the safety device each time before operation
• Do not reach under the protective cover during operation
• Remove any jewelry
• Wear a hair net if necessary
© Festo Didactic 8121048
NOTE
Switch off both the operating power and the control power before working on
the circuit.
Only reach into the setup when it is at a complete standstill.
Be aware of potential overtravel times for the actuators.
CAUTION
WARNING
WARNING
Servo brake and drive system
51