Festo TP1410 Instrucciones De Utilizacion página 65

Servo brake and drive system
How to install the test specimen:
1. Switch off the power switch and main switch.
2. Undo both quick clamping levers (A) at the test bench (vertical position).
3. Press both clamping levers (B) together on the test specimen and keep them pressed.
4. Insert the mounting plate of the test specimen in the grooves of the console housing.
Fig. similar
5. Push the test specimen up to the servo brake motor until the limit switch (C) is actuated.
6. Clamp the test specimen tight on the console housing. To do so, release both clamping levers (B) (they
clamp automatically). Then shift the quick clamping lever (A).
65
© Festo Didactic 8121048