Residual Risks; Intended Use; Environmental Protection - Kärcher MT CS 250/36 Manual De Instrucciones

shaft connection of the rod and the cutting tool are se-
curely fastened.
ATTENTION
● Only store the device indoors.
Safe transport and storage
WARNING
● Switch the device off, allow it to
cool down and remove the battery pack before storage
or transportation. ● Cover the cutting tool with the bar
scrabbard before storing or transporting the device.
CAUTION
● Risk of injury and damage to the
device. Secure the device against movement or falling
down during transport.
ATTENTION
● Remove all foreign bodies from the
device before storage or transportation. ● Store the de-
vice in a dry, well ventilated location out of the reach of
children. Keep the device away from corrosive sub-
stances such as garden chemicals. ● Do not store the
device outdoors. ● Make sure the chain is lightly oiled
when storing the device for more than one month. The
manufacturer recommends using a spray for rust pro-
tection and oiling. Ask your Customer Service depart-
ment to recommend a suitable spray.
Safe servicing and care
Note
● Service and maintenance work may only be
performed by suitably qualified and specially trained
personnel. We recommend sending the product to an
authorised service centre for repair. ● You may only
perform the adjustments and repairs described in these
operating instructions. Contact your authorised Cus-
tomer Service department for other repairs.
WARNING
● Risk of injury. The saw chain is
extremely sharp. Wear suitable protective gloves when
performing chain maintenance and when cleaning, se-
curing or removing the bar scrabbard. ● Follow the in-
structions for chain tensioning, chain tension
adjustment and chain lubrication. ● Severe injuries due
to kickback if a damaged chain is not replaced or re-
paired. ● Turn off the motor and remove the battery
pack before cleaning or servicing the device. ● Ensure
that the device is in a safe condition by regularly check-
ing that all bolts, nuts and screws are screwed tight.
● Risk of injury due to long, uninterrupted use of the de-
vice. Take regular breaks while working with the device.
CAUTION
● Only use accessories and spare
parts and attachments that are approved by the manu-
facturer. Only original spare parts, original accessories
and original attachments ensure fault-free and safe op-
eration of the device.
ATTENTION
● Clean the product with a soft, dry
cloth each time after use.

Residual risks

WARNING
● Certain residual risks remain present, even when the
device is operated in the prescribed manner. The fol-
lowing dangers can be present when using the de-
vice:
● Vibration can cause injuries. Use the correct tools
for the job, use the handles provided and restrict the
working time and hazard exposure time.
● Noise can cause hearing injuries. Wear hearing pro-
tection and limit the duration of exposure.
● Incision injuries on contact with exposed saw teeth
of the saw chain.
● Incision injuries due to unforeseen, abrupt move-
ments or kickback of the guide rail.
● Incision injuries / risk of injection by parts flying away
from the saw chain.
● Injuries caused by hurled objects (wood shavings,
splinters).
● Injuries due to falling objects. Always wear a suita-
ble protective helmet when working overhead.
● Inhalation of dust and particles.
● Skin contact with the lubricant / oil.
CAUTION
● Using the device for longer periods can cause poor
circulation in the hands due to vibrations. A general
period of use cannot be set, because this depends on
several influencing factors:
● Personal tendency to suffer from poor circulation
(frequently cold fingers, tingling sensation in the fin-
gers)
● Low ambient temperature. Wear warm gloves to
protect your hands.
● Holding the device too tightly hindering blood circu-
lation.
● Continuous operation is more harmful than opera-
tion interrupted by work breaks.
You should see a doctor if using the device regularly
and for lengthy periods of time, and in the event of re-
peated occurrences of symptoms such as tingling in
the fingers or cold fingers.
DANGER
Improper use
Danger of death from incision injuries
Only use the device for its proper use.
● The pole saw accessory is suitable for commercial
use.
● The accessory is intended for use with the MT 36 Bp
Multi-Tool.
● The device is intended for outdoor use only.
● For safety reasons, always hold the device firmly
with both hands.
● The device is intended for pruning and trimming
small branches and twigs high on a tree. The user
stands securely on the ground.
Any other use, e.g. when climbing, for pruning low
branches or for cutting material at ground level is pro-
hibited. The user shall be liable for hazards arising as a
result of improper use.

Environmental protection

The packing materials can be recycled. Please
dispose of packaging in accordance with the en-
vironmental regulations.
Electrical and electronic appliances contain valu-
able, recyclable materials and often components
such as batteries, rechargeable batteries or oil,
which - if handled or disposed of incorrectly - can
pose a potential threat to human health and the environ-
ment. However, these components are required for the
correct operation of the appliance. Appliances marked
by this symbol are not allowed to be disposed of togeth-
er with the household rubbish.
Notes on the content materials (REACH)
Current information on content materials can be found
at: www.kaercher.com/REACH
English
Risk reduction

Intended use

13