Publicidad
Idiomas disponibles
Idiomas disponibles
1. Your cover is backed with a soft mildew resistant porous backing. Under normal conditions, it is not necessary to remove your
cover if it has become wet underneath. However, if your vehicle is not in motion and excessive moisture and strong direct sun
rays are directed at your cover, remove the cover until both the vehicle and cover are completely dry!
2. Keep the underneath of your cover as clean as possible at all times. Remove monthly or as necessary and clean away dust
and debris.
3. Fresh repainted areas of your vehicle in contact with the cover must be completely cured. Check with your painter about
adequate cure times.
4. When you first try to fit the cover to your vehicle it may appear to be undersized. This is due to the nature of the special vinyl
used which will stretch during installation to insure a tight fit. For this reason, initial installation of the mask is best performed
when the cover is warm.
5. Use only a mild soap to clean your cover. Do not use harsh soaps, strong detergents or vinyl protectant/sealant type products
as they may destroy the special finish of your new cover. Allow your cover to dry completely before reinstalling on your
vehicle.
6. It is important that you remove your front end cover before you take your vehicle through an automatic car wash. Failure to do
so may cause damage to your front end cover.
7. DURING VERY HIGH TEMPERATURES AND SEVERE DRIVING CONDITIONS, WHEN EXTRA COOLING CAPACITY IS
NEEDED, IT MAY HELP TO REMOVE THE CAR COVER.
1. Place lower portion of the front end cover over fenders and grille of your vehicle. If you are going to use a front license plate,
snip the black threads on the back of the license plate patch. Slip the vehicle license plate bracket through this opening.
Once the bracket is fed through, shape the front end cover around the bumper one side at a time.
2. Attach all other fastening points per illustration.
Insert tab between fascia and seal around the headlamp.
CAUTION: Do not allow the seal to be pressed into the gap.
A thin plastic shim may be used to position the seal aside
prior to inserting the tab.
Corvette Front End Cover
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EX-
ACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GMSPO SPECIFICATIONS.
REVISION
AUTH
Attach plastic clips to the edge of
the sheet metal.
REV 02JA08
PART NO.
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette Front End Cover
PART NO.
88968131
6200 Grand Pointe Dr., Grand Blanc, MI 48439
88968131
SHEET
2
SHEET
2
9
OF
9
OF
Publicidad
