Descargar Imprimir esta página

GM 19201150 Guia De Inicio Rapido página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

Rear Bumper Protective Film
Contents:
Description
Protective Film
Alcohol Wipes
Instruction Sheet
Special Chemicals:
1. Spray Bottle of wetting agent (which is a solution of soap
and water. 20% alcohol, 1 oz. of dish soap to 1 gallon
ofwater).
Special Tools:
1. Heat gun (optional)
2. Application Squeegee
Preparation:
• Verify all parts are present.
• Avoid installing film in direct sunlight or extreme cold or heat.
• Installation Area should be clean and well-lit to ensure the
best possible results of the application. Installation area
needs to be clean and free of dust, grease, dirt and other
object which can become airborne.
Vehicle Surface Preparation:
1. Clean the entire area where the film is to be applied with
soap and water. Rinse and dry thoroughly.
2. Clean the entire area where the film is to be applied with
alcohol wipe. Dry wipe completely.
3. Thoroughly wash hands to make sure they are clean and
free of lint, grease, dirt, etc.
Rear Bumper Protective Film
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCOR-
DANCE WITH GMSPO SPECIFI-
CATIONS.
Quantity
1
1
1
REVISION
AUTH
Installation:
4. While holding one of the pre-mask tabs, carefully peel the
release liner from the film. Once removed, spray vehicle
surface and adhesive side of film liberally with wetting
solution. (See Figure 1)
FIGURE 1
Clear Protective Film
Adhesive Side
Release Liner
5. Using the body features and trunklid striker, place the film,
adhesive side down, onto the rear bumper. The notch in the
center of the premask should align with the trunklid striker.
Figure 2.
FIGURE 2
C e n t e r
Notch
Note: Striker to Center Notch Alignment
NOTE: Some parts may contain a center notch at the top only.
PART NO.
IR 18AU08
INSTALLATION INSTRUCTIONS
DR
TITLE
Rear Bumper Protective Film
PART NO.
19201150
6200 Grand Pointe Dr., Grand Blanc, MI 48439
Application
Fluid
Application
Trunklid
Striker
19201150
SHEET
2
SHEET
Fluid
2
9
OF
9
OF

Publicidad

loading