Waterpik SinuSense Folleto De Instrucciones página 5

7. Install the fl ow tube onto the hose fi tting. Press until it does not come off
when pulled gently.
8. Replace blue reservoir by aligning the raised tick marks on the blue
reservoir and white housing (fi gure 8a). Turn the reservoir counter-
clockwise a quarter turn (fi gure 8b).
9. Install self-sealing SoftSeal™ nozzle onto nozzle tip. Two tips are included
to accommodate multiple users.
Battery Notice:
• Diff erent types of batteries or new and used batteries are not
to be mixed.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the water pulsator and
properly disposed.
• The supply terminals are not to be short-circuited.
• Do not dispose of batteries in fi re.
• Replace batteries when the power or sound of the unit begins to
sound weak during use.
You will need 8 ounces of warm distilled water, 1 Waterpik® SinuSense™
Water Pulsator, 1 self-sealing SoftSeal™ nozzle, and 1–2 Soothing Saline
Easy-Pour Packs (1 pack is recommended for most users). It's best to use
the water pulsator as part of your morning ritual. You should not practice
nasal cleansing 1 hour before going to bed to allow for proper drainage.
Clean your water pulsator thoroughly before each use (refer to cleaning
instructions). Have tissues ready before performing sinus wash.
8 E N G L I S H
All manuals and user guides at all-guides.com
7 3a
8 3b
a
8 4
b
9 7
Performing Sinus Wash with Your
®
Waterpik SinuSense
1. Wash hands before each use.
2. Remove reservoir by turning it clockwise from the white housing.
3. Tear open Soothing Saline Easy-Pour Pack and empty into water
reservoir.
4. Fill the reservoir to the top fi ll line with 8 ounces (240ml) of distilled
water and heat in microwave at 5-second intervals to desired
temperature. Or fi ll the reservoir to the top fi ll line with 8 ounces (240ml)
of warm distilled or purifi ed water. (Warm tap water may be used but
is not recommended.) Caution: Do not microwave water pulsator, only
microwave the water reservoir with water in it. Do not use hot or
boiling water.
5. Fasten reservoir to the white housing by aligning the raised tick marks
and turning the reservoir counter-clockwise a quarter turn to tighten.
8OZ
6. Gently shake to mix the solution.
7. Hold the water pulsator with your forefi nger on the trigger, being careful
not to squeeze trigger.
Meijer.com
™
Water Pulsator
E N G L I S H 9