Panasonic AJ-YCX250G Guia De Instalacion página 4

Installation into the AJ-HPM200
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire
or electric shock do not perform any servicing other than that contained in the installation guide unless
you are qualified to do so.
1
Make sure that the power of the AJ-HPM200
is turned off.
2
Loosen the 7 screws on the AJ-HPM200,
and remove the top panel.
Screws
Installation into the AJ-HPD2500
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire
or electric shock do not perform any servicing other than that contained in the installation guide unless
you are qualified to do so.
1
Unscrew the two screws from the
AJ-YCX250G to remove the bracket.
Bracket
2
Make sure that the power of the
AJ-HPD2500 is turned off.
E-3
3
Screws
4
3
Screws
Place the AJ-YCX250G into the terminal
running along the slot of AJ-HPM200, and
secure it using the two 3.0 mm screws.
Replace the top panel, and screw it on.
Unscrew the two screws from the
AJ-HPD2500 to remove the top panel.
Slot
Screws