MATTRESS FIRM 100 I/C-UBL Manual Del Propietário página 7

STEP 6
Plug electrical power cord into a working, grounded electrical outlet.
Note: An electrical surge protection device is recommended (not included).
STEP 7
Briefly activate all functions of the base with the remote control to verify
all features are in working order. If base does not operate, refer to the
Troubleshooting section of this manual.
STEP 8
Return base to the level position.
STEP 9
Install the mattress retainer by placing the mattress retainer ends in the
holes at the foot end of the base. Make sure horizontal bar section is flush
against the base (FIGURE 2).
FIGURE 2
STEP 10
Place mattress on base to complete assembly.
INSTALLATION
MATTRESS
RETAINER
100 I/C-UBL Adjustable Base Owners Manual 290-0029-d
7