Gym Master GM97816 Manual De Instrucciones página 16

CLEANING
Remove dust on the treadmill with vacuum or slightly damp cloth. Fold up the deck and
clean the floor with vacuum periodically will help to prolong the treadmill product life.
Never use solvents on the deck or running belt. Use of solvents can reduce critical
lubrication of the deck and belt.
RUNNING BELT CENTERING ADJUSTMENT
When you run or walk, you may push off harder with one foot than the other. This will
cause the running belt to run off centered. This treadmill is designed and built to ensure
proper tracking of the belt is always centered on the deck.
need further adjustment to keep it centered. To center the belt, use the enclosed Allen
wrench to adjust the rear roller position.
RUNNING BELT CENTERING PROCEDURE
1. Do not wear loose clothing, neckties, or loose jewelry while making this adjustment.
2. Never turn the bolts more than 1/4 turn at a time.
3. Always tighten one side and loosen the other to prevent over tightening or loosing the
belt.
4. Run the treadmill. Adjust belt while the treadmill is running at 4 Mi/H (6.4 Km/H) with
no person on the belt.
After making the adjustment walk on the belt for five minutes to test. If necessary, repeat
the procedure but never turn the bolts more than 1/4 turn at a time. Over tightening the
belt can significantly shorten the belt life.
IF BELT TOO FAR TO THE LEFT SIDE:
1. Turn the left roller bolt 1/4 turn clockwise (tighten)
2. Turn the right roller bolt 1/4 turn counterclockwise (loosen)
IF BELT TOO FAR TO THE RIGHT SIDE:
1. Turn the right roller bolt 1/4 turn clockwise (tighten)
2. Turn the left roller bolt 1/4 turn counterclockwise (loosen)
RUNNING BELT TENSIONING ADJUSTMENT
If when you plant your foot on the belt, you can feel a slipping sensation then the belt has
stretched and is slipping across the rollers. All belts will stretch over time. This is a normal
and common adjustment on any treadmill. To eliminate this slipping, tension both Allen
bolts on the rear roller 1/4 turn as shown. Try the treadmill again to check for slipping.
Repeat if necessary, but never turn the roller bolts more than 1/4 turn at a time.
Owner's Manual
MAINTENANCE
15
Occasionally the belt may
16