Installation Steps; Care And Cleaning - LUND Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Insert visor rear flange first. Rear
flange inserts between the trim and
the exterior surface. The front & top
flange slides into the window chan-
nel.
3
NOTE: It is necessary to both hold the visor up into the
window channel AND pull the bottom of the visor slightly
outward while raising the glass to seat visor properly.
5
4 Piece Set
Install the rear visor using the same preparation and installation methods as front visor. Note
that the top & rear flanges slide into the window channel, and the front flange fits between the
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Lund
and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in terms of
fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
Repeat steps 1 thru 7 for remaining visors
®
branded products offered by Lund International, Inc. We take the utmost pride in our products
Lund International
800-241-7219 • Visit us at lundinternational.com
© 2016 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
Apply pressure to all flange edges to ensure proper
adhesion. Remove tape liner by pulling on free ends.
4
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
6
If the visor does not seat correctly, roll down
rubber & window frame.
Page 2 of 2
window and repeat Step 5.