Avocent SwitchView 1000 Guía De Uso E Instalación página 8

2 SwitchView 1000 Switch Installer/User Guide
• Upgrade cable
• Ground terminator
Installation
If you are installing your SwitchView 1000 switch to a PS/2 interface,
you must power down all servers before connecting your switch to a
server to ensure proper installation. USB interfaces do not need to be
powered down before installation.
NOTE: Linux users may experience mouse failure if hot-plugging directly to the
SwitchView 1000 switch. If your mouse becomes locked, use the mouse reset
hotkeys (see Appendix A ) to reset your mouse, or turn the Linux server off before
connecting it to the SwitchView 1000 switch.
Plug one end of the supplied power cord into the back of the switch and
the other end into an appropriate power source. Connect the local
keyboard, monitor and mouse cables to the appropriate ports on the rear
of your SwitchView 1000 switch.
Connect your servers to an available port on the rear of your
SwitchView 1000 switch using the cable appropriate for your interface.
Power up all connected servers. Keyboard and mouse recognition is
now activated and your SwitchView 1000 switch is ready for operation.
Figure 1.2 on page 3 shows a basic configuration for the SwitchView
1000 switch.