Installation Steps - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps

Scuff rubber mounting surface.
1
Apply surface prep to rubber surface.
3
CAUTION: Read surface prep warning
on page 1 before continuing.
Attach visor to door while making sure all areas of the
mounting surface are flush. It may be necessary to
open the door and apply pressure from behind the top
of the frame to ensure a flush mounting surface.
5
Installation Steps - 4 Piece Set
Scuff rubber mounting surface.
7
NOTE: Actual application may vary slightly from illustrations.
2
Remove tape liner from front & rear flanges. Peel back
2" (5 cm) of tape liner from each end of top flange.
rear
flange
4
Remove tape liner and apply pressure to tape flanges to
6
8
Page 2 of 3
Clean mounting surface.
top flange
front flange
secure.
Clean mounting surface.