Care And Cleaning - AVS Ventvisor Deflector Instrucciones De Instalación

Installation Steps
Apply surface prep to rubber surface.
9
CAUTION: Read surface prep warning
on page 1 before continuing.
Attach visor to door while making sure all areas of the
mounting surface are flush. It may be necessary to
open the door and apply pressure from behind the top
of the frame to ensure a flush mounting surface.
11

Care and Cleaning

•
Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost
pride in our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your
product is top quality in terms of fit, durability, finish and ease of installation.
™ Auto Ventshade
NOTE: Actual application may vary slightly from illustrations.
Repeat Steps 1-12 for passenger side.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Remove tape liner from front & rear flanges. Peel back
2" (5 cm) of tape liner from each end of top flange.
10
rear
flange
Remove tape liner and apply pressure to tape flanges to
12
logo are trademarks of Lund International, Inc.
TM
Page 3 of 3
top flange
secure.
front flange