TSG WINTER HELMET Manual Del Usuario página 6

All manuals and user guides at all-guides.com
HOW TO CUSTOMIZE YOUR FIT
Our Tuned Fit System allows you to dial in your fit using different thickness
comfort pads on the interior of the helmet. Your helmet comes with two sizes
of comfort pads. Carefully separate the Velcro strips at room temperature to
remove the pads on the inside of the helmet and swap them for the thickness
you need. Your helmet package contains spare fastening points in case one
of the Velcro fastening points becomes detached. If the helmet still does not
fit after having adjusted it with the pads, choose another size. Comfort pads
can be purchased separately in all the various sizes.
HELMETS WITH FLEXTECH INNER-SHELL
If you have purchased a TSG helmet with FlexTech Technology, you will
note the inner shell of your helmet consists of several EPS foam segments
which are connected with a strong nylon webbing tape. These individual
segments are slightly adjustable and therefore adapt perfectly to your head
shape. Our FlexTech Technology increases comfort, whilst completely
fulfilling all legal norms regarding design and impact protection.
HELMETS WITH DIAL-FIT SYSTEM
If you have purchased a TSG helmet with Dial-Fit System, you can size adjust
your helmet by dial. To tighten the dial, turn it clockwise to a comfortable fit.
To loosen, turn the dial counterclockwise. The fit should be snug, but not
uncomfortably tight. Be sure to check the adjustment of your helmet before
each ride. The Dial Fit System is designed to enhance the fit and stability of
your helmet. It is not a replacement for your helmet's straps. Do not attempt
to remove the fit system from your helmet; doing so will void all of the helmet's
warranties.
HOW TO REMOVE YOUR EARPADS
You can easily turn your helmet from winter into spring modus by removing
the earpads. Just open the snap-fasteners and pull the straps out through
the loops on the earpads. Detach the neckroll by carefully pulling the pins
out of the EPS foam. Then carefully pull earpads straight up and out from
the helmet shell. Reinstall by pushing the earpad into the slot between shell
and foam and click the neckroll pins back into the embedded holes of the
foam. The soft side of the earpad should face inward, and the neckroll should
run along the back of the helmet. Then install the left side earpad, thread
the helmet's straps back trough the earpads strap loops and close all snap-
fasteners.
For our light inmold helmet models carefully remove the earpads (attached to
the helmets with snaps) one at a time by gripping them and pressing them out
004 – ENGLISH