List Of Available Models; Identification Labels; Receiving And Storage - WEG CFW701 Manual Del Usuario

2.4 LIST OF AVAILABLE MODELS

The available inverter models are listed in
and Table B.3 on page

2.5 IDENTIFICATION LABELS

There are two nameplates on the CFW701: one complete nameplate is affixed to the side of the
inverter and a simplified one is located under the keypad. Please refer to
139 to verify the position of these labels on the product. The nameplate under the keypad
allows the identification of the most important characteristics of the inverter even if they are
mounted side-by-side. When there is more than one inverter it is necessary to be careful not to
exchange the inverter covers (front cover in case of inverters frame sizes A, B or C and control
rack cover for inverters frame sizes D and E) because there are individual information labels
under the keypad of each inverter.
WEG part number
Serial number
CFW701 model
WEG part number
Inverter net weight
Input rated data (voltage,
number of phases, rated
currents for operation with
ND and HD overload cycles,
and frequency)
Current specifications
for operation with normal
overload cycle (ND)
Current specifications
for operation with heavy
overload cycle (HD)

2.6 RECEIVING AND STORAGE

The CFW701 comes packaged in a cardboard box up to frame size C inverter models. The
bigger models are packed in wooden box. There is an identification label affixed to the outside
of this package, the same one that is affixed to the side of the CFW701 inverter.
Table B.1 on page
150.
(a) Nameplate located under the keypad
(b) Nameplate affixed to the side of the inverter
Figure 2.2: (a) and (b) Nameplates
General Instructions
148, Table B.2 on page 149
Figure A.2 on page
CFW701 model
Manufacturing date
Manufacturing date
Serial number
Maximum ambient
temperature (without
derating) for ND overload
with open spaces for
ventilation around the
inverter (refer to the
dimensions A, B, C and
D in Figure B.3 on page
171)
Output rated data
(voltage, number of
phases, rated currents for
operation with ND and HD
overload cycles, overload
currents for 1 min and 3 s,
and frequency range)
The maximum output
frequency depends on the
settings of the motor rated
frequency, control mode
and inverter switching
frequency. For further
details, see Table 8.1 on
page 40.
CFW701 | 7