Unit Assembly - Uline EPOXY WIRE SHELVING Instrucciones De Ensamblaje

Figure 3
Figure 4
Figure 5
Figure 6
PAGE 2 OF 6

UNIT ASSEMBLY

1. Start with the lowest shelf. Snap the interlocking pieces of a
shelf support (wide end down) around the post at the lowest
groove where shelf is to be located. Slide the support up or
down until it snaps onto the groove. Add a shelf support to the
same place on the remaining posts. (See Figure 3)
NOTE: NSF requires food service applications to keep the
lowest shelf at least 6" above the floor.
2. Slide posts through underside of shelf until shelf slides firmly
over supports. (See Figure 4)
3. Stand unit upright. Gently tap shelf down to secure it. (See Figure 5)
4. Determine the height of the next shelf, snap on shelf supports, then
add and secure shelf. Repeat Step 4 to add the remaining
shelves. (See Figure 6)
1-800-295-5510
uline.com
0221 IH-3818