Checking/Test Running And Configuring The Control Panels; General; Meaning Led Indicator Lights; Switching On A Panel - Vetus THRUSTER RimDrive RD125 Instrucciones De Instalación

7

Checking/test running and configuring the control panels

7 .1

General

• Switch on the main switch.
After switching on the power a beep will sound at each control panel
fitted.
The system is now in 'stand-by' . The panel or both the panels are not
activated.
7 .2

Meaning LED indicator lights

For the meaning of the LED indicator lights, see table page
7 .3

Switching on a panel

• Press the 'ON/OFF' switch twice.
After the switch is pressed once the LED will flash green and the
buzzer will sound continuously didididididi..... (. . . . . . .) The 'ON/OFF'
switch must be pressed a second time within 6 seconds. The LED
(blue) will remain on and the buzzer will confirm that the panel is
ready for use by giving the signal dahdidah (- . -).
If a second panel is connected the LED on the panel 'which has not
been switched ON' will flash (every second two short blue flashes,
heartbeat)
7 .5

Restore factory settings

Switch off all control panels (see 7.4) and perform the following actions to restore the factory settings of one panel:
1
30 seconds
1. Press and hold the "ON /
OFF" button for 30 seconds.
7 .6

Configuring the panels

• Implement the configuration or
the panel for controlling a bow
or stern thruster as in section 7.7.
• Implement the configuration for
the helm station where the panel
is sited as in section 7.8.
• If during test running it emerges
that the movement of the boat
is opposite to the direction the
joystick is moved in, this can be
modified as indicated in 7.9.
vetus® Installation instructions thruster RIM DRIVE 250 mm
152
2
RED, quick ashing
dahdidididah ( - . . . - )
2. After 30 seconds the LED on the upper left is quick flashing red
and the LED at the upper right is green. You hear the signal,
dah-di-di-di-dah (-... -). Now release the "ON / OFF" button.
OF
2
3
1
Do not test the bow thruster when the boat is out of the water
unless you are convinced that everyone is at a safe distance
from the propeller tunnel .
For the operation of a CAN-bus controlled (V-CAN) bow and stern
thruster a single DBPPJA panel can also be used. For installation and
configuration see the separate manual of the DBPPJA.
ON/OFF
BPPPA
7 .4

Switching OFF a panel

Press once the 'ON/OFF' switch, the buzzer will reply with the signal
didididahdidah ( . . . - . - ).
• Turn off the battery main switch when leaving the boat.
3
GREEN
3. Press the "ON / OFF" button once.
All LEDs are off and you hear the signal,
di-dah-di (.-.). The control panel has
now been reset to factory settings.
Keep to the following sequence for configuring the panels:
1) Configuring a panel for operating a bow or stern thruster (see
section 7.7),
2) Configuring a panel for the helm station where the panel is
situated (see section 7.8),
3) Changing the thrust force direction (only if this proves neces-
sary during test running, see section 7.9).
The illustrated operations must be performed on EACH panel in-
stalled .
ENGLISH
W
arninG
t
ip
ON/OFF
BPPJA
1 x
n
ote
020574.06
29