ATLINKS 29451 Manual Del Usuario página 8

• Two single RJ11 wall jacks.
Connect the other end of the line cord
to a 2-line adapter (not
provided). Then connect the adapter to
the wall jacks with two short tele-
phone line cords (also not provided).
If you want to connect LINE 3 and 4, use
the same procedure as in step 1.
2. For the handset, connect one end of
the coiled handset cord to the jack on
the side of the base unit. Take the
other end of the cord and plug it into
the jack at the bottom of the handset.
Then place the handset in the cradle.
3. Plug the AC power supply cord into
the jack on the back of the unit labeled
AC 9V. Thread the cord behind the
strain relief to stabilize the cord to
prevent it from disconnecting easily.
Then plug the AC power supply into
an electrical outlet.
4. Follow the steps in "Setting Up Your
Station Address" to continue install-
ing your phone.
CAUTION: Use only the ATLINKS USA, Inc. 5-2418 power supply that is
compatible with this unit. Using other power supplies may damage the unit.
8
All manuals and user guides at all-guides.com
2
STORE IN TIMER TIME SET MEMO
1 2 3
5 6 7
PAGE
9 10 11
13 14 15
BUSY REDIAL FLASH PAUSE
1 2
PRIVACY
ABC
4 5
GHI JKL
7 8
PQRS TUV
VOLUME
* 0
T ONE OPER
HEADSET MUTE SPEAKERPHONE
3
REVIEW LOWER
4
8
12
16
TRANSFER CONF CALL
3
DEF LINE 4
6
MNO LINE 3
9
LINE 2
WXYZ
#
LINE 1
HOLD INTERCOM