Troubleshooting; Scrapping - Advance Terra 4300 Instrucciones De Uso

ENGLISH

TROUBLESHOOTING

Problem
The machine does not start when turning the
ignition key to "I".
The machine does not move when pressing
the pedal.
The main broom does not work.
The side brooms do not operate.
The machine collects little debris/dust.
The fi lter shaker does not operate.
The machine operates only when stationary,
otherwise the red warning light turns on.
The battery autonomy is low.
The drive system electronic board malfunction
led is fl ashing.
For further information contact a Advance Dealer, where it is possible to consult the Service Manual.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
– Batteries
– Polyester dust fi lter
– Main and side brooms
– Plastic components
– Electrical and electronic components (*)
(*) Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
24
INSTRUCTION FOR USE
The battery connector is disconnected.
The F1 fuse in the box is open.
The battery charger cable is connected to the
electrical mains.
The parking brake is engaged.
When starting the machine with the ignition key,
the pedal is pressed, or the operator is not yet
on the driver's seat.
The FT fuse is open.
The FA fuse is deactivated.
The main broom is not lowered.
The FB fuse is deactivated.
The vacuum system is turned off.
The F4 fuse in the box is open.
The dust fi lter is clogged.
The hopper is full.
The skirts are not properly adjusted or are worn. Adjust/replace the skirts.
The brooms are not properly adjusted.
The F2 fuse in the box is open.
The batteries are discharged.
The batteries are dead.
The battery capacity is low.
The drive system is malfunctioning.
1464035000(1)2009-06
Possible cause
Terra™ 4300B
Remedy
Connect the battery connector.
Replace the fuse.
Disconnect the battery charger cable from the
electrical mains.
Disengage the parking brake.
Start the machine with the ignition key, only after
being on the driver's seat and without pressing
the pedal.
Replace the fuse.
Reset the fuse by pressing the relevant switch.
Lower the main broom.
Reset the fuse by pressing the relevant switch.
Turn on the vacuum system with the switch.
Replace the fuse.
Clean the dust fi lter by using the fi lter shaker or
by disassembling it.
Empty the hopper.
Adjust the broom height.
Replace the fuse.
Charge the batteries.
If the problem persists, replace the batteries.
Replace the batteries.
Buy batteries with higher capacity (see the
Technical Data paragraph).
To detect the failure, refer to the Service Manual
(at any Advance Dealer).