Whittier Wood Products 499W Instrucciones Para Armar página 7

P x16
Q x4
FIG. 10
SQUARE THE BOTTOM SECTION:
10. With the unit laying face down on a protective surface, measure from left corner of Center
Shelf to bottom right corner of unit (
/
Center Shelf (
corner of unit until measurements are equal. If line (
See FIGURE 10.
Fasten the Lower Back Panel (L) to the unit through the pre-drilled holes in the back panel
using the #6 x 5/8" Philtruss Screw (P). Back should line up fl ush to Bottom Shelf and centered
side to side. Be careful not to over-tighten the screws as you might strip the wood.
Screw four #6 x 5/8" Philtruss Screws (P) with Finish Washers (Q) between the back panels
into the Center Shelf (F). Screws should line up with screws in the Upper and Lower Back
Panels. See FIGURE 10.
FIG. 11
INSERTING THE GLIDES:
11. Tap the Tack Glides (R) into the Lower Side Panels (C and D) near the back.
Thread the adjustable Glides (S) on the Plastic Inserts (T). See FIGURE 11a. Tap into holes
in the bottom of the side panels. See FIGURE 11.
All manuals and user guides at all-guides.com
P
Q
/
). Measurements should be equal. If line (
P
P
Q
P
Q
P
Q
P
P
Q
P
P
P
) and from bottom left corner of unit to right corner of
/
) is longer, tap right corner of unit.
R x2
P
P
P
P
P
P
P
/
) is longer, tap bottom left
S x2
R
R
S T
FIG. 11a
498W & 499W – PAGE 7
T x2
S
T