Sample Inlet Filter - GMI PS500 Manual Del Usuario

USER HANDBOOK

4.2.2 Sample Inlet Filter

1. Using a No.1 Pozidrive
retaining screws, then remove the sample line connector.
Fig. 4.3 Sample Line Connector
2. Push the sample inlet filter out.
3. Fit a new Sample Inlet Filter (Part No. 66084).
4. Replace the sample line connector. The sample line
connector is moulded to fit in one direction only.
5. Replace the two retaining screws.
Note: Do not over-tighten the screws.
4-4
screwdriver, remove the two
®
SAMPLE LINE CONNECTOR
RETAINING SCREWS