English; Software Loading And/Or Updating - IRTEC smart Manual De Instrucciones

ENGLISH

10. Software loading and/or updating

This procedure allows you to install/update the software of the display, the new version (supplied
exclusively by the manufacturer) must be present inside the root of a USB storage device that must be
inserted in the back of the device.
Before starting the update operations it is advisable to identify all mechanical parameters of the
machine in order to restore them if required.
First of all the display must be switched off, this can be done by holding the external on/off button for more
than 5 seconds, after which the following page will appear.
Once the storage operations have been completed, the display will fully turn off. After a few seconds the
software update procedure can be performed.
A. Turn on the display by pressing and holding keys F1 and F2.
B. Once the display is on, the following screen will appear for a few seconds in sequence.
C. At this point the system asks you to insert the flash drive with the new software version into the USB
port installed on the back of the display.
44
82
83
84
SMART
20/01/2020