Water Consumption And Hour Counter Data - IRTEC smart Manual De Instrucciones

F1
F2
F3
F4
In which you can configure the field, adding F6 or removing F7 sectors and changing the length by using
the selection wheel/button and the F5 key for the scale. The lower part of the screen contains the
modification boxes, those on the left (white) represent the distance from the machine of every single sector,
while on the right (grey) the lengths of every single sector are displayed using the trolley position as point 0.
Specifically:
1-White box (420.0m) the first sector ends at 420m from the machine (naturally it starts at the maximum
extension of the hose, in this case 800m).
Grey box (288.7m) is the length of the first sector considering the current position of the trolley.
2-White box (220.0m) the second sector ends at 220m from the machine.
Grey box (200.0m) is the overall length of the second sector.
3-White box (10.0m) the third sector ends at 10m from the machine and, being the last one, this is the
arrival point.
Grey box (210.0m) is the overall length of the third sector.
13.6.

Water consumption and hour counter data.

From the main page it is possible (via F2) to access the screen (for consultation only) which displays water
consumption and working hours.
The available data is the following:

Water consumption in m
then the value is purely theoretical

Water consumption in m
not present then the value is also in this case purely theoretical.

Instantaneous flow rate value in l/min obtained from the litre counter if present or calculated
theoretically from the pressure value and the size of the raingun.

Number of partial/total hours worked,
64
145
146
3
from start-up (first upper box), if the electronic litre counter is not present
3
of the last work cycle (upper central box), if the electronic litre counter is
F5
F6
F7
F8
SMART
20/01/2020