Sms Modem Alarm List - IRTEC smart Manual De Instrucciones

a. Check the data entered in the anti-slipping system configuration chapter 5.4.
b. Check the actual efficiency of the mechanical system (the correct arrangement of the
chains).
c. Check the electrical connection of the inductive sensor by referring to the diagram figure 1.
11- Chain slipping sensor FAULT.
a. Check the electrical connection of the inductive sensor by referring to the diagram figure 1.
b. Replace the sensor if required.
12- Inconsistent machine configuration data.
a. Check all configuration data entered and restart the device chapter 0.
14.2.

SMS modem alarm list.

This page is accessed from the generic alarms page by using the F2 key to display all alarms concerning
the modem.
101- No SIM alarm.
102- SIM configuration alarm, it must be inserted into a phone and reset.
103- Network registration failed alarm.
104- Insufficient network signal alarm.
105
106-Messages to be SENT buffer full alarm, the modem cannot send messages.
107- At least one phone number in the send list cannot be reached.
108-
109-
110-
111-Message arrived from unknown number not listed.
112- Message arrived with invalid command.
68
152
SMART
20/01/2020