Roadstar CLR-2618 Manual De Instrucciones página 4

All manuals and user guides at all-guides.com
18. DISPLAY LOW / HIGH DIMMER
19. FMANTENNA WIRE
20. ACPOWERCORD
POWERSUPPLY
This unit operates from a main supply of 230V ~ 50Hz. Connect the
AC power cord to the AC household main outlet. Ensure that the
voltage is as indicated on the rating plate on the rear of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time
and alarm settings in the event of a temporary power interruption.
Install a 3V CR2032 flat lithium battery (not included), into the battery
compartment located on the bottom of the unit.
If power is temporarily interrupted the display will blink and the radio
will not play. However, the battery back-up circuit will continue to
maintain the clock and alarm settings. When power is restored the
clock will display the correct time and alarm settings, and no
adjustment is necessary.
Note: If power is interrupted and there is no battery in the compartment
or the battery is exhausted. The time and alarm settings will be
lost. When power is restored the clock will begin to flash
indicating that the time and alarm settings must be corrected.
English 3 4
SETTINGTHECORRECTTIME
1. With the Radio Off, press and hold the TIME SET button (2).
2. Press the HOURbutton (6) to advance hour, press MINUTE button
(4) until the correct time is displayed.
3. Release the TIME SET Button.
SETTINGTHE WAKEUPTIME
1. Press and hold the ALARM SET button (8).
2. Press the HOURbutton (6) to advance hour, press MINUTE button
(4) until the correct time is displayed.
3. Release the ALARM SET button.
WAKETOBUZZERALARM
1. Set the alarm time as shown above.
2. Set the ALARM SWITCH (3) to the BUZZER position.
3. Set the ALARM ON/OFF button (5) to ON (Clock icon appears).
WAKETOTHE RADIO
1. Set the alarm time as shown above.
2. Set the ALARM SWITCH (3) to the RADIO position.
3. Set the Band Selector (7) to the desired radio band, and follow
English