en-us
Problem
Water droplets are
forming inside the
appliance.
Drawers can only be
closed with great
difficulty.
Ice and water dispenser
Problem
The water filter symbol
is flashing.
The ice maker is not
making enough ice
cubes or the ice
cubes are deformed.
The ice maker is not
making enough ice
cubes or any ice
cubes at all.
The ice cube
container contains ice
cubes that are not
being dispensed.
The ice maker is not
making ice cubes.
30
Possible cause
Humidity is too high or doors have been
opened frequently.
The door seals are not tight.
The drawer has not been inserted
correctly.
The drawer rails are dirty.
Possible cause
The filter cartridge is old.
After replacing the filter cartridge, the
water filter symbol was not reset.
The appliance or ice maker was just
recently switched on.
A large amount of ice has been taken out.
Water pressure is too low.
The filter cartridge is clogged or old.
When switching from ice cubes to
crushed ice, an ice cube may become
jammed inside the dispenser opening.
The ice cube will begin to melt and water
will drip into the ice and water dispenser.
There is a layer of ice on the screw
conveyor.
Ice cubes are frozen to one another.
The ice maker is switched off.
The appliance is not being supplied with
water.
The water connection line has kinks in it.
Water pressure is too low.
Freezer compartment temperature too
high.
The ice cube container is not inserted
correctly.
The water connection is installed
incorrectly.
Corrective action
Do not open doors as frequently or do not
keep them open too long.
Check the door seals and foldaway door bar;
if necessary, clean or correct position.
Insert the drawer correctly.
Clean the drawer rails.
Corrective action
Replace the filter cartridge.
Reset the water filter symbol.
It takes approx. 24 hours before it starts
making ice.
It takes approx. 24 hours before the ice
storage bin is full again.
Have the water pressure checked.
Replace the filter cartridge.
Release the jammed ice cube from the
dispenser opening using a blunt plastic tool.
Do not use sharp or pointy objects as this
could damage the appliance.
Remove and clean the ice cube container.
Remove and clean the ice cube container.
Switch on the ice maker.
Have a qualified technician check the water
connection.
Shut off the water supply. Straighten out the
kinks. Have damaged water connection lines
replaced with original manufacturer parts.
Have the water pressure checked.
Set a slightly colder temperature for the
freezer compartment.
Insert the ice cube container correctly.
If the water connection is not installed
correctly, this can cause low water pressure
and can damage the appliance.