Setting The Temperature - Sinbo SSI 2872 ÜTÜ Manual De Instrucciones

• To disconnect. Remove plug from outlet. Let iron cool completely before putting away.
• Loop cord loosely around iron when storing.
• Burns can occur from touching hot metal parts, hot water, or steam. Use caution when turning the
iron upside down, there may be hot water in the water tank.
• If an extension cord is absolutely necessary, a 10 ampere cord should be used.
• Do not use this appliance for anything else other than its intended use. This appliance is for household
use only.
3. HINTS BEFORE FIRST USE
• Some parts of the iron have been slightly greased and as a result the iron might smoke slightly when
switched 'ON' for the first time. After a short while, this will cease.
• Before using for the first time remove any sticker or protective foil from the soleplate with a soft
cloth.
• Keep the soleplate smooth: do not scratch against metal objects (e.g. rack of ironing board, buttons,
zippers)
• Pure woolen fabrics (100% wool) may be pressed with the iron set to a steam position. Preferably
select steam selector position and use a dry pressing cloth.

4. SETTING THE TEMPERATURE

• Always check first to see whether ironing instructions are attached to the article to be ironed (they
can be found on a label showing a drawing of an iron. The numbers of dots indicate the correct
temperature. Refer to the indications on the temperature dial and in the table below). Follow these
ironing instructions in all cases.
• If ironing instructions are missing but you do know the kind of fabric, then see the below. The table
is valid for the actual materials and do not concern any applied finish, gloss etc.
• Textile to which some kind of finish has been applied (gloss, wrinkle relief etc.) can best be ironed
on somewhat lower temperatures.
• Sort the fabrics out according to ironing temperature first: wool with wool, cotton with cotton, etc.
The iron heats up quicker than it cool downs. Therefore, start ironing the articles requiring the lowest
temperature such as those made of synthetic fibres. Then progress to higher ones.
• Turn the temperature control knob round until it is opposite the setting pointer.
Textile Temperature control
MIN Synthetics Low temperature
• Silk Normal temperature
•• Wool Normal temperature
••• Cotton Normal & high temperature
MAX linen High temperature
5. HOW TO FILL WITH WATER
• Remove the plug from the stock
• Fill the water through the filling opening into the water tank.
• If the water is very hard, it is advised to use distilled water or demineralized water only. Do not use
chemically descaled water.
• Pour out the remaining water after use.
6. FUNCTIONS DESCRIPTION
Dry ironing:
Turn the steam control to minimum position ,set the temperature control to the suitable position, you
can dry ironing.
Instruction on label
Always Refer
Always Refer
Always Refer
Always Refer
Always Refer
- 8 -