Installation - Manupro MPASP4IN1 Manual De Instrucciones

Suction performance
Protection category
Protection class
Technical changes reserved!

7. Installation

m ATTENTION!
Prior to use, ensure that the device has
been correctly and fully assembled.
Unpacking (Fig. A+B+C)
Release the locking hooks (4) and remove
the machine head (2). The accessories
are located inside the stainless steel con-
tainer (8).
Only the plastic extension tubes (3x) (8)
are located outside the stainless steel
container, in the packaging. Remove all of
the accessories from the stainless steel
container (8).
Installing the castor mounts (fig. D+E)
1. Turn the stainless steel container (9)
upside-down (the machine head (2)
must be removed).
2. Push the castor mounts (5) into the
cut-outs provided on the wheel mount-
ing base (7). (4x)
3. Fasten the castor mounts (5) with a
screwdriver (not included in the deliv-
ery) and one screw each (21). (4x)
Installing the castors (fig. F)
Press the four castors (6) into the holes in
the castor mounts (5).
16 kPa
Installing the machine head (2) and the
handle (1)(Fig. G)
IPX4
1. Place the machine head (2) on the
II
stainless steel container (8). Secure
the machine head (2) with the locking
hooks (4). When installing the ma-
chine head (2), ensure that the locking
hooks (4) latch into place correctly.
2. Place the handle (1) on the machine
head (2) and fasten it with two screws
(21) with a screwdriver (not included in
the delivery).
Installing the foam filter (H) (fig. 3+8)
Never use the device without filter! Al-
ways ensure that the filters are cor-
rectly fitted!
Installing the foam filter (15): For wet vacu-
uming, slide the foam filter (15) provided over
the filter basket with safety float valve (13).
Installing the HEPA filter (17) (fig. I)
For dry vacuuming, slide the HEPA filter
(17) provided over the filter basket with
safety float valve (13). The HEPA filter (17)
is only suitable for dry vacuuming!
Installing the paper filter bag (16) (fig. J)
It is recommended to use an additional
paper filter bag (16) when vacuuming fine,
dry dirt. Slide the paper filter bag (16) over
the suction opening in the stainless steel
container (9). The paper filter bag (16) is
only suitable for dry vacuuming. The pa-
per filter bag (16) makes it easier to dis-
pose of the dust collected.
Installing the suction hose (fig. K+L)
Connect the suction hose (14) to the cor-
responding port, depending on the de-
sired use, on the wet and dry vacuum.
GB | 21