Shredder C Apacity - Bonsaii C220-A Instrucciones De Operación

Placing the shredder
1. Place the device on a smooth flat surface.
2. Ensure the de
3. Where possible, avoid using extension c
connect the device directly to the wall socket using the power cable (in accordance
with the technical specifica
4. Plug the power cable into a standard 220-240-volt AC outlet.
Opera the shredder
A main switch is located on the back of the machine, while a slide switch is on the top of
the device and can be set in thr
1. AUTO: when the device is connected to power, and the main switch on the back of the
machine is on, the power ligh
ted as soon as paper or credit card is inserted into the corresponding feed slot.
Please do not insert any credit cards into the feed slot while shredding paper since the
device is incapable of shredding of paper a
chosen material has fully passed thr
automa ally.
2. REV is used to fix paper blockages. This chang
cle has ended enabling the blades to be released. If you realise that you have
uninten
bly slower, set the switch t
3. The switch should be set to OFF if you wish to empty the paper basket, or do not inte-
nd to use the device for an ext
the power supply.
The device is only intended for indoor use and for an int
maximum of 5 minutes. Do not use the shredder for commercial purposes or outdoors.

Shredder c apacity

The C220-A is capable of shredding up to 12 sheets of paper (DIN A4, 80g/m²) into cross
cut at once. Paper width may not exceed 220mm. When shredding small pieces of paper,
such as envelopes or credit card receipts, the paper should be inserted in the middle of
the slot. Please ensure that you never insert more than the stated maximum quan
int
t a distance from heaters and other sources of heat.
ed too much paper, and the shredding process bec
y damage the device.
ay sockets. It is advisable to
ocess is automa ally
o remove excess paper.
er doing so, unplug the device from
10
edit cards. Once the
ocess will stop
fore an opera-
ent opera