Turning Off - Bonsaii C220-A Instrucciones De Operación

The C220-B is capable of shredding up to 10 sheets of paper (DIN A4, 80g/m²) into micro
cut at once. Paper width may not exceed 220mm. When shredding small pieces of paper,
such as envelopes or credit card receipts, the paper should be inserted in the middle of
the slot. Please ensure that you never insert more than the stated maximum quan
int
Start opera
er c
"AUTO", the device will then be ready to use.
Shredding paper
Insert several sheets of paper (80g/m²) in portrait orienta
paper will be detected by the sensor
automa ally drawn in. The opera
Shredding Credit Card
Insert the card into the top center of the feed opening. You can only cut up one credit
card at a single pass.
Overloading
If you insert too much paper over the maximum shred capacity of the shredder, the indi-
ca t will be red flashing
the switch to "REV" to remove the paper. Reduce the number of sheets and try again.
Overhea
If the shredder working con
es, there is a possibility of the motor overhea
a t will be r
the "OFF
automa ally disconnected from the power and will restart on its own once the motor
has cooled down sufficiently.
Turning off
Set the switch to "OFF" to turn the device off en ely once you finish shredding. The
power light will be off.
y damage the device.
er, turn on the main switch, slide the switch on the top housing to
t the device cool down for about 45 minutes. The device will be
tart and the paper will be
e is no more paper in the
top rota
xceeding the indicated maximum opera
top. You should therefore set the switch to
11
to the feed slot. The
vent, set
vent, the indic-