PNI SmartHome RG120LR Manual De Instrucciones página 10

1. Wall
2. Garage door
3. Sensor cable
4. Wired sensor
5. Sensor magnet (fixed on the garage door)
6. Sensor cable
7. Relay
8. Red/black wires
9. Garage door opening button
First step: Power the relay using the power adapter in the package.
Second step: Connect the relay to the door opener (meaning to the wires leading
to the garage door opener).
Insert the red/black wire plug into the relay. Then connect the 2 wires to the
garage door motor (automation) in the same connectors where the wires leading
to the wall-mounted opening button are connected.
Third step: Connect the sensor to the garage door.
Connect the sensor connector to the relay. Then mount the wired sensor on the
wall and the magnet on the garage door so that you get a distance between the
2 elements of 3-15 mm. Use the mounting accessories in the box (screws, nails,
cables).
Note: If it is difficult to install with screws, you can use the double-sided tape in the
package as an alternative.
For a secure fixing you can use both elements: screws + double sided adhesive tape.
8