Torin BIG RED 1500-LB El Manual Del Propietario página 12

TO REPLACE JACK OIL:
1. Remove the hydraulic ram assembly from the
frame
1. Position the jack on level ground and lower the
saddle.
2. Open release valve by turning handle counter-
clockwise.
3. Remove the oil fill plug.
4. Turn the jack on its side to drain old oil from the
oil fill hole.
5. Position the jack on level ground and keep saddle
in the lowered position.
6. Fill the oil case until oil level is just beneath the
lower rim.
KEEP DIRT AND OTHER MATERIAL CLEAR
WHEN POURING.
All manuals and user guides at all-guides.com
7. Replace oil fill plug.
8. Replace the hydraulic ram assembly on the frame
9. Perform the Air Purge Procedure.
ADDITIONAL WARNINGS:
▪ DO NOT USE MOTOR OIL IN THE JACK.
▪ ONLY USE ANTI-FOAMING JACK OIL.
▪ ALWAYS USE A GOOD GRADE HYDRAULIC
JACK OIL.
▪ DO NOT USE HYDRAULIC BRAKE FLUID,
ALCOHOL, GLYCERINE, DETERGENT, MOTOR
OIL OR DIRTY OIL.
▪ USE OF A NON-RECOMMENDED FLUID
CANCAUSE DAMAGE TO A JACK.
▪ AVOID MIXING DIFFERENT TYPES OF FLUID
AND NEVER USE BRAKE FLUID, TURBINE
OIL, TRANSMISSION FLUID, MOTOR OIL OR
GLYCERIN. IMPROPER FLUID CAN CAUSE
PREMATURE FAILURE OF THE JACK AND THE
POTENTIAL FOR SUDDEN AND IMMEDIATE
LOSS OF LOAD.
▪ DISPOSE OF HYDRAULIC FLUID IN
ACCORDANCE WITH LOCAL REGULATIONS.
12