Troubleshooting - Affinity iLumaLight El Manual Del Propietario

TROUBLESHOOTING

Problem
Cannot close
case
Will not turn on
Inside of case
is wet
Turns On/Off
at the wrong
times
LIMITED WARRANTY
This product is guaranteed against defect in material and workmanship for one
year. If this product is defective, your exclusive remedy will be a replacement
product of equal value. Expenses for removal and replacement are not
covered.
This guarantee does not apply to any products which are modified in any way
or used in any type of installation or unit other than conventional water closets.
We assume no liability for toilet seats modified or installed on anything other
than conventional water closets.
6
Solution
1. Make sure the battery is installed correctly.
2. Make sure top cover is properly aligned.
3. Make sure rubber gasket o-ring is correctly placed.
1. Make sure the battery is installed correctly. Replace if
needed.
2. Press black button to restart 8-hour light cycle at desired
time.
3. Make sure it is dark enough for the light sensor to operate
properly.
1. Open case and remove battery. Dry terminals.
2. Clean the battery clips. Dry any moisture found on inside
of the case.
3. Allow to fully dry by keeping the case open for an
extended period of time.
4. Reinstall battery, aligning with + and - markings.
IMPORTANT! Liquids inside the product may cause
contact corrosion and failure of product to operate.
Liquids can damage electronic components. DO NOT
immerse in any liquids or spray with any liquids. The
product enclosure is liquid resistant, but not sealed. Make
sure the rubber gasket o-ring is seated in the enclosure
groove and align the enclosure tabs properly when
assembling after inserting the battery.
1. Press the black button at the desired start time to restart
the 8-hour "ON" cycle.
2. Make sure the sensor lens on the top of the case is clean
and not blocked by any debris.
For product information and videos visit:
www.AffinitySeats.com