Canopy Assembly; Blade Assembly; Motor Housing - Craftmade ATA52ABZ5 Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy. Press up
gently but firmly on canopy cover until you
hear it snap onto the bottom of the canopy.

8. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 15 blade attachment screws and
washers in one of the hardware packs. Hold
blade plate up to blade, aligning posts in
blade plate with holes in blade as shown,
then lower blade arm over blade holes on
other side of blade--note label on blade arm
indicating THIS SIDE UP. Insert 3 blade
attachment screws (along with washers) with
fingers first and then tighten screws securely
with a Phillips screwdriver. Repeat for the
remaining blades.
Remove blade arm screws/lock washers from
underside of motor. Align blade arm holes
with motor screw holes and attach blade arm
with blade arm screws/lock washers. [Note:
Use slot located on motor plate for access to
motor screw holes with screwdriver.] Before
securing screws permanently, repeat with
remaining blade arms. Secure all screws.
Note: Tighten blade arm screws twice a year.
All manuals and user guides at all-guides.com
THIS SIDE UP
blade arm screws/
lock washers
page 6
canopy
canopy cover

motor housing

blade plate
hanging
bracket
motor plate
blade attachment
screws and washers
blade arm
blade