ZAMST IW-1 Instrucciones De Uso página 2

How to use Ice Bag
• Before using this product, carefully read the "Precautions for use - Be sure to read this" section. Then follow the steps provided to ensure the
product is correctly used.
Approximately
3/4-full level
How to apply
• Before attaching this product, carefully read the "Precautions for
use - Be sure to read this" section. Then follow the steps provided to
ensure the product is correctly attached.
How to apply IW-1
1.
Put the ice bag(s) inside the ice bag pocket and pull it
into shape.
2.
Attach the product to the area you want to cool, and
fasten the temporary hook-and-loop fastener to the
product. If the temporary fastening strap feels excessively
tight, you do not need to attach it. If you are not using the
temporary fastening strap, fasten the temporary fastening
hook-and-loop fastener to the napping fabric for the
temporary fastening strap.
Temporary
fastening strap
3.
Wrap the straps. Make sure that the icing wrap is not
loose or misaligned. If you feel any discomfort, repeat the
steps from the beginning to reattach the product.
Strap B
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer
directly. It is only necessary to notify the manufacturer and the competent authority of
the member state in the event of any serious incidents that could lead to a significant
deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice
for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and
regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any
defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon
Sigmax Co., Ltd in Japan, the United States and other countries.
1.
Fill the ice bag 3/4 full with ice. Adding some water to the bag will help it conform to the
shape of your body.
2.
Let as much air out as possible before screwing the cap on tightly.
3.
Apply the ice bag to the desired area.
Strap A
How to apply IW-2
• Put the ice bag(s) inside the ice bag pocket(s) and pull it into shape. There
are three ice bag pockets. Put the ice bag(s) in the pocket(s) so that the
ice bag(s) is appropriately positioned for the area you want to cool.
 Attaching the product to your shoulder
1.
Attach one end of the hook-and-loop fastener of the fix
strap provided together with the product to the approximate
location indicated in the illustration shown below.
Fix strap
<When attaching to right shoulder>
2.
Attach the product to the part of your shoulder you want to
cool while holding the product with the finger hole on the front.
Hook your finger into the finger hole. Pull the elastic strap with
that finger and wrap it around your body, then fasten it.
3.
Pull the fix strap and attach it to the front of the icing wrap.
Make sure that the icing wrap is not loose or misaligned.
If you feel any discomfort, repeat the steps from the
beginning to reattach the product.
 Attaching the product to your lower back
Attach the icing wrap to the area you want to cool. Pull the elastic
strap and fasten the hook-and-loop faster. The fix strap provided with
the product is not used.
<When attaching to left shoulder>
Elastic
strap