Test Button; Status Led - Phottix Strato TTL Manual De Instrucciones

sync mode will not support Second Curtain
Sync (SCS) functions.
-If not using a 1Dx camera ensure this mode
is disabled for best results.
Turning transmitter and receiver on/
off
1 . To t u r n o n t h e P h o t t i x S t r a t o T T L
transmitter or receiver– move the power
switch to the "ON" position.
2 . To t u r n o f f t h e P h o t t i x S t r a t o T T L
transmitter or receiver - move the power
switch to the "OFF" position.

Test Button

1. The Test Button will test fire flashes/strobes.
EN
2. To Test: Press the transmitter Test Button.
Flashes connected to Phottix Strato TTL
receivers on the same channel will fire when
the transmitter test button is pressed.
3. Pressing the receiver Test Button will test
fire flashes or strobes connected to that
receiver.
For Wireless Shutter Release: See Using the
Strato TTL as a wireless shutter release below

Status LED

1. The Status LED on the Strato TTL transmitter
will flash green once every 2 seconds while
the power is on and turn solid green upon a
half-press of the shutter button (on camera
or the Strato TTL transmitter being used as
INSTRUCTION MANUAL
7