Operation; Vacuuming Dry Materials - RIDGID WD5500 Manual Del Propietário

SP6755 RIDGID 5 Gallon

Operation

!
WARNING: To reduce the risk of fire, explosion, or damage to Vac:
• Do not leave Vac running while unattended - you may fail to notice important
signs indicating abnormal operation such as loss of suction, debris/liquid
exiting exhaust, or abnormal motor noises. Immediately stop using Vac if
you notice these signs.
• Do not leave Vac plugged-in when not in use.
• Do not continue running when float has cut off suction.
• Do not operate Vac in areas with flammable gases, vapors or explosive dust
in the air. Sparks inside the motor can ignite airborne flammables.
Flammable gases and vapors include: lighter fluid, solvent-type cleaners,
oil-based paints, gasoline, alcohol, or aerosol sprays. Flammable dusts
include: coal, magnesium, aluminum, grain, or gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not use Vac as a sprayer.
!
WARNING: To reduce the risk of electric shock or injury:
• Do not expose to rain or allow liquid to enter motor compartment. Store
indoors.
• Do not handle plug, switch, or Vac with wet hands.
• Do not service Vac while it is plugged-in. If your Vac is not working as it
should, has missing parts, has been dropped, damaged, left outdoors, or
dropped into water, return it to an independent service center or call
customer service.
• When using an extension cord, use only outdoor-rated cords that are in
good condition. Do not allow the connection to come into contact with
liquid.
• Do not vacuum toxic materials to reduce the risk of inhaling the vapors or
dust.
To reduce the risk of electric shock, this
Vac has a polarized plug (one blade is
wider than the other except 230 volt
models). This plug will fit in a polarized
outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet.
Do not change the plug in any way.
After you plug the power cord into the
outlet, turn the unit on by pushing the
switch from position "O" to position "l".
The symbols used on the switch actuator
are international "On & Off" symbols. "O"
is the symbol for "OFF" and "l" is the
symbol for "ON".
= OFF
2/11/10 10:10 AM
All manuals and user guides at all-guides.com
= ON
13
Page 13

Vacuuming Dry Materials

1. The filter must be properly installed to
avoid leaks and possible damage to
Vac.
2. If you are picking up fine dust, it will be
necessary to empty the drum and
clean the filter more frequently to
maintain peak Vac performance.
NOTE: A dry filter is necessary to pick up
dry material. If you use your Vac to pick
up dust when the filter is wet, the filter will
clog quickly and be very difficult to clean.