Tabla de contenido
Publicidad
GB
GB
SECURE THE WORK PIECE
Wherever possible secure the work piece using
clamps or a vice.
t is safer than using your hand and leaves both
hands free to control the power tool.
DO NOT OVER-REACH
Do not over-reach, keep proper footing and
maintain your balance at all times.
MAINTAIN TOOLS WITH CARE
Keep cutting tools sharp and clean for better
and safer performance.
Follow the instructions for lubricating and
changing accessories.
Check the tool power cord periodically and if
damaged have it replaced by an authorised
service facility.
Inspect extension cords periodically and if dam-
aged replace it.
Keep handles dry, clean and free from oil and
grease.
Ensure that ventilation slots are kept clean and
free from dust at all times. Blocked ventilation
slots can cause overheating and damage to the
motor.
DISCONNECT POWER TOOLS
Ensure that power tools are disconnected from
the mains supply when not in use, before serv-
icing, lubricating or making adjustments and
when changing accessories such as blades, bits
and cutters.
REMOVE ADJUSTING KEYS AND
WRENCHES
Form the habit of always checking to see that
keys and adjusting wrenches are removed from
the power tool before turning it on.
AVOID UNINTENTIONAL STARTING
Ensure that the switch is in the OFF position
before plugging the power tool into the mains
supply.
EXTENSION CORDS AND REELS
DO NOT use 2 core extension cords or reels on
power tools with an earth path. Always use a 3
core extension cord or reel with the earth core
connected to earth.
When the power tool is to be used outdoors,
use only extension cords intended for outdoor
use and are so marked.
Always unwind any extension cords fully.
For extension cords upto 15 metres use a wire
cross section of 1.5mm2 .
For extension cords over 15 metres but less
than 40 metres use a wire cross section of
2.5mm
2
Always replace a damaged extension cord
before using it.
Protect your extension cord from sharp objects,
excessive heat and damp or wet locations.
STAY ALERT
Watch what you are doing, use common sense,
and do not operate the power tool when you
are tired, if taking medication that causes
drowsiness, when having consumed alcohol or
taken drugs.
Check Damaged Parts Before using the power
tool it should be carefully checked to determine
that it will operate properly and perform its
intended function.
Check for the correct alignment of moving
parts ensuring they do not bind. Check for bro-
ken or missing parts and have them replaced or
repaired at an authorised service centre. If the
power tool requires mounting make sure it is
securely attached to a suitable work bench.
Check any other condition that may affect the
operation of the power tool.
A guard or any other part of the power tool
that is damaged should be properly repaired or
replaced by an authorised service centre unless
otherwise indicated in this instruction manual.
Any switch that does not operate correctly
must be replaced by an authorised service cen-
tre.
Do not use the power tool if the ON/OFF switch
does not turn the power tool ON and OFF.
WARNING!
Do not attempt to modify the power tool in
any way. The use of any attachment or accesso-
ry other than those recommended in this
instruction manual could result in damage to
the power tool and injury to the operator.
Have your power tool repaired by a qualified
person.
This electric power tool complies with national
and international standards and safety require-
ments.
14
10
Publicidad
Tabla de contenido
