Nova IR-150 Manual De Instrucciones página 8

7. Always take care when you are ironing in the presence of children, and if children are using the iron.
Never leave an iron unsupervised when it is switched on, even on an ironing board.
8. Touching hot metal parts, hot water or steam can result in burns and scalds. Take care if you hold
the iron upside-down: there could be hot water in the reservoir.
9. Repairs may only be carried out by a recognised service centre.
10. After using the iron, press the steam button a few times and shake carefully until you are sure that
all the water has been removed from the reservoir. The remaining moisture will evaporate if you then
insert the plug into the electricity socket and allow the iron to heat up for a short time.
11. Avoid overloading your domestic electric system, and do not connect other appliances that use a lot
of electricity to the same ring main as the iron.
12. Only use extension leads with a diameter of at least 1 mm2. Extension leads of a smaller diameter
may overheat. Always position extension leads so that nobody can pull at them or trip over them.
13. Check regularly that the cable is not damaged and can still be used safely.
14. Never iron over zips, rivets in jeans etc; these will damage the plate of the iron. Iron around such
objects.
15. Never dismantle and repair the iron yourself.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE
BROWN
GREEN/YELLOW
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured red.
The wire which is coloured GREEN/YELLOW must be connected to the terminal which is marked with
the letter E or and is coloured GREEN or GREEN/YELLOW
WARNING: THIS APPLIANCE MUST BE EARTHED
NOVA STEAM STATION
UNIQUEMENT POUR UN USAGE DOMESTIQUE
Avant d'utiliser le fer à repasser, veuillez lire attentivement ce mode d'emploi.
DESCRIPTION DES PIECES DU FER A REPASSER
A. Réservoir vapeur
1. Interrupteur de la vapeur
B. Interrupteur du fer à repasser
C. Orifice de remplissage avec bouchon
D. Position de repassage
E. Boutons vapeur
(en haut = vapeur,
en bas = arrêt + jet de vapeur)
F. Témoin lumineux
G. Thermostat
H. Semelle
I. Entrée cordon
J. Cordon de raccordement au secteur
K. Régulateur de vapeur
UTILISATION DU FER A REPASSER
La première fois
1. Si vous utilisez le fer pour la première fois, vérifiez que la tension
indiquée sous le fer correspond à la tension du secteur auquel vous
souhaitez raccorder le fer.
All manuals and user guides at all-guides.com
NEUTRAL
LIVE
EARTH
ART. IR-150
8