Black and Decker JU350S Manual De Instrucciones página 15

Explosive gases. Prevent flames and sparks and provide
adequate ventilation during charging
Reverse polarity indicator
Fail-safe isolating transformer. The mains supply is
electrically separated from the transformer output.
This appliance is intended for indoor use only
SPECIFIC SAFETY INSTRUCTIONS
FOR JUMP STARTERS
Vehicles may have electrical and electronic systems
(e.g. engine management system, mobile phone) that
may be damaged if subjected to high starting voltages
and voltage peaks. Before connecting the appliance to
the vehicle read the vehicle's owner's manual to confirm
that external-starting assistance is allowed.
Follow these instructions and those published by the
battery manufacturer, vehicle manufacturer and
manufacturer of any equipment you intend to use with
this unit. Review warning labels on these products and
on the vehicle.
This appliance is not designed to be used as a replacement
for a vehicular battery. Do not attempt to operate a vehicle
that does not have a battery installed.
The appliance must only be connected to a 12V leadacid
battery.
Warning! Do not use the appliance for charging dry-cell
batteries that are commonly used with home appliances.
These batteries may burst and cause injury to persons or
damage to property.
Check the polarity of the vehicle battery terminals
before connecting the appliance. Always disconnect the
negative (black) jumper cable first: followed by the
positive (red) jumper cable.
The ON/OFF switch should be in the OFF position
before connection to a power source or load, when the
unit is charging and when not in use.
Warning! Never allow the red and black clamps to touch
each other or another common metal conductor. This could
cause damage to the appliance and/or create a sparking/
explosion hazard. Always store the battery clamps in the
built-in holsters when not in use.
When using this unit in proximity to the vehicle's battery
and engine, stand the unit on a flat, stable surface, and
be sure to keep all clamps, cords, clothing and body parts
away from moving parts of the vehicle.
This appliance contains a sealed lead-acid battery. It is
recommended that the appliance is laid flat during
storage, use, and recharging.
Warning! Explosive gas may be vented from the lead acid
batteries when charging and under extreme conditions
battery leakage may occur. Ensure the area is well ventilated
when conducting jump starting and charging procedures.
All manuals and user guides at all-guides.com
Warning
1. Risk of explosive gas mixture. Connect and disconnect
2. Battery lead connection: for a battery installed in a
3. Do not overcharge battery - see instruction manual
4. Do not smoke, strike a match or cause a spark in vicinity
5. Use in a well ventilated area.
6. This equipment employs parts, such as switches and
15
To reduce the risk of electric shock, disconnect the
appliance from any power source before cleaning.
Turning off controls without disconnecting the appliance
will not reduce this risk.
Make sure the appliance is disconnected from all charging
power sources before beginning the jump start procedure.
battery leads only when supply cord is disconnected.
vehicle, first connect charger output lead to ungrounded
battery post-not connected to automobile chassis-in
accordance with polarity identification and then opposite
polarity lead to chassis away from battery; do not connect
to carburetor or fuel lines. Disconnect chassis lead first.
For battery not installed in vehicle, refer to instruction manual.
of a battery
relays, that can produce arc or sparks, therefore, if used
in garage, locate in a room or enclosure provided for the
purpose or no less than 18 inches above the floor.
ADDITIONAL SAFETY WARNINGS
FOR INFLATORS
(Only for JU450CB)
For home and car use only. Inflate car and bike tyres,
balls, rafts, swimming pool floats, air mattresses, and
more in and around the home.
The compressed air from your inflator is not safe for
breathing. Never inhale air from your inflator or from a
breathing device connected to the inflator.
Inflate items only to their manufacturer's recommendations.
Exceeding the pressure rating could cause them to explode
resulting in personal injury.
Do not leave inflator running unattended. It could burst
tyres or other items.
Since the vibration produced by the inflator may cause
it to "walk", do not operate on a high shelf or other surface.
Operate at ground or bench level.
Do not modify or attempt to repair. Never drill into, weld,
or make any modifications to the inflator or its attachments.
Do not operate inflator when the car engine is running.
Operate only with the accessories included or those rated
for 8.28 bar/120 p.s.i. or higher. The use of any accessory
not recommended for use with this tool could be hazardous.
Do not play with the tool. High pressure air is dangerous.
Don't direct air-flow at yourself or others.
The inflator can become hot during use. Allow inflator to
cool for 30 minutes before storing away.
ENGLISH