Parts List - LUND Summit Ridge 2.0 Instrucciones De Instalación

PARTS LIST:

2 SR2 Running Boards
1 Driver/Left Front Mounting Bracket
1 Passenger/Right Front Mounting Bracket
1 Driver/Left Center Mounting Bracket
1 Passenger/Right Center Mounting Bracket
2 Driver/Left Rear Mounting Brackets
Passenger/Right
Center Bracket
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. USE ILLUSTRATION TO IDENTIFY BRACKETS AND RUNNING BOARDS.
2. Starting on the passenger side, front of the vehicle, remove the plastic plugs or hex bolts covering the
(2) threaded holes in the body panel, (Figure 1). Select the passenger side Front Mounting Bracket,
(Figure 2). Attach the Bracket to the vehicle using the included (2) 8mm Hex Bolts, (2) 8mm Lock
Washers and (2) 8mm Flat Washers, (Figure 3). Do not tighten hardware at this time.
3. Next, move to the 2nd mounting location, (Figure 5). Select the passenger side center Mounting
Bracket, (Figure 4). IMPORTANT: The Center and Rear Brackets look similar but each one is unique.
Use the illustration above and Figure 4 to help identify each Bracket. Repeat Step 2 to install the
center Mounting Bracket, (Figures 6 & 7).
4. Move along to the 3rd mounting location, (Figures 8). Repeat Step 2 to install (1) Passenger side Rear
Mounting Bracket, (Figure 9).
5. Continue to the last, 4th, mounting location at the back of the cab, (Figure 10). Repeat Step 2 to install
the passenger side rear Bracket, (Figure 11). When properly installed, the cradles for the Running
Board will face toward the front.
6. Once all (4) Brackets have been fully installed, carefully unwrap (1) Running Board. Place the Running
Board on top of the (4) Brackets. Locate the channels in the bottom of the Running Board. Select (4)
8mm Double Bolt Plates, (Figure 12). Insert the Bolt Plates into the channels in the bottom of the
Running Board closest to the Brackets, (Figure 13). Lift the Running Board up and guide the studs
down through the Brackets.
7. Attach the Running Board to the Mounting Brackets with the included (8) 8mm Flat Washers and (8)
8mm Nylon Lock Nuts, (Figures 14—17). Do not tighten at this time.
8. Level and adjust the Running Board as desired and tighten all hardware.
9. Repeat Steps 2—8 for driver side Running Board installation.
(2) Passenger/Right Rear
Mounting Brackets
Passenger/Right
Front Bracket
2 Passenger/Right Rear Mounting Brackets
8 8mm Double Bolt Plates
16 8-1.25 x 30mm Hex Bolts
32 8mm x 24mm Flat Washers
16 8mm Lock Washers
16 8-1.25mm Nylon Lock Nuts
(2) Driver/Left Side Rear
Mounting Brackets
(8) 8mm Double
Bolt Plates
Driver/Left
Front Bracket
Page 1 of 5
SR2 RUNNING BOARDS
07-17 TOYOTA TUNDRA CREWMAX
Driver/Left side
Center Bracket
11/27/17 (RA)