Charging (Fi G 2) - Fieldmann FZN 4000 A Manual Del Usuario

While charging, the charger and the battery may be warm to touch. This is a normal event and does not
indicate any problem.
Whenever possible use the charger at standard room temperature. To prevent the charger from overheating,
do not cover the battery and do not charge in direct sunlight or in the vicinity of heat sources.
If the battery is not being properly charged:
1. connect a lamp or another device to the power socket to check the current in the socket.
2. place the charger and battery in a location where the temperature is in the range of approximately 18 - 24 C.
3. if problems with charging persist, have the charger and tool repaired at an authorised service centre or the
vendor.
Charging (fi g 2)
Make sure that you have read all the safety instructions
provided in this user's manual before using the
charger.
This product must not be repaired by the user.
The charger must be repaired by an authorised service
centre or organised by the vendor so as to prevent
damaging the internal components.
1. Insert the charger adapter connector into the
socket in the shears (Fig. 2, point 2)
2. Connect the charger adapter to the mains power
socket
(230 V 50 Hz) (Fig. 2, point 1)
3. The lit red diode (Fig 2, point 3) signalises that the
battery is charging. The battery is fully charged
when this red diode turns off.
CORDLESS GARDEN SHEARS
11 EN
Before using
Fig. 2
USER'S MANUAL