Assembling The Power Tool; Before Using; Important Safety Instructions For Chargers - Fieldmann FZN 4000 A Manual Del Usuario

4. ASSEMBLING THE POWER TOOL

1. The product is fully assembled.

5. BEFORE USING

The battery must be recharged before use. Charging time is approx. 3 – 5 hours.

Important safety instructions for chargers

Read all instructions and warnings located on the charger, battery and tool before using the charger and in this
manual.
DANGER! The charger clamps have 230V. Do not probe with conductive items. Danger of serious or fatal
injury by electrical shock.
The charger and battery are specifi cally designed to work together. DO NOT ATTEMPT to charge the battery in
a different charger than the charger included with the shears.
Do not expose the charger to rain or snow.
This charger is not designed for any use other than charging the rechargeable batteries of these shears. Any
other use may lead to a fi re or serious or fatal injury by electrical shock.
The charger and battery are specifi cally designed to work together. DO NOT ATTEMPT to charge the battery in
a different charger than the charger included with the shears.
Do not expose the charger to rain or snow.
This charger is not designed for any use other than charging the rechargeable batteries of these shears. Any
other use may lead to a fi re or serious or fatal injury by electrical shock.
In order to limit the risk of damaging the power plug or power cord, always disconnect by pulling on the plug
and not the power cord.
Make sure that the cord is not placed in such a way that it is stepped on, tripped over or that it is not
damaged or otherwise exposed to stress.
The charger is ventilated by slot openings located in the top and bottom part of the charger. Do not place any
items on the top part of the charger and do not place the charger on such surfaces, which could block these
openings, which would lead to excessive temperatures inside the charger.
Keep the charger at a suffi cient distance from sources of heat.
Do not use the charger if it has been impacted by something or if it has fallen or has been damaged in any
other way.
Do not disassemble the charger. Have the charger maintained or repaired at an authorised service centre or
the vendor. Incorrectly performed assembly may lead to a fi re or serious or fatal injury by electrical shock.
In order to limit the risk of injury by electrical shock, always disconnect the charger from the mains power
socket before cleaning it.
Never attempt to connect two chargers to one another.
CORDLESS GARDEN SHEARS
Assembling the power tool | Before using 9 EN
USER'S MANUAL