Help
Many common problems are caused by the telephone and power cables being incorrectly connected, not
connected at all, or the power being turned off. Please check that your Daewoo DTD-7000 has been
correctly set up.
No display: The batteries may be flat or dead. Recharge or replace the batteries.
No dial tone: Is the telephone line cord plugged into the telephone wall socket?
Check that the base station is connected to the mains power and switched on.
You cannot link up with the base station
Is the icon flashing in the display? The mains power cable may not be connected at the base or switched
on. Are you in range of the base? Move closer to the base. The batteries could be low or flat. Recharge
or replace the batteries.
No ring on the handset
Check that the base station is plugged into the phone socket and that the mains power is switched on.
The ringer volume may be set too low for you. See user guide to adjust the volume.
Buzzing noise on my radio, TV, computer or hearing aid
Sometimes your Daewoo DTD-7000 can interfere with other electrical equipment if it is placed too close.
It is recommended that you place your Daewoo DTD-7000 at least one metre away from such
appliances to avoid any risk of interference.
The handset charger is not working
Check that the power adaptor is properly plugged into the charger. Make sure your handset has slotted
correctly into the charger. Check the batteries are fitted correctly into the handset.
Check the base is plugged into a working mains power socket and that the power is switched on.
Caller's number is not displayed even though you have subscribed to a Caller Display service
The number has been withheld by the caller, is unavailable or is an international call.
Caller's name is not displayed even though their number is stored in the Phonebook
When storing Phonebook numbers, you must remember to store the full number, including the dialling
code. Only exact name/number matches will allow the name to be displayed.
All manuals and user guides at all-guides.com
20