Technical Data - unGer HydroPower Ultra UHP01 Manual Del Usuario

3. REPLACE ULTRA RESIN PACKS
• Install new Ultra Resin Packs (fig. H) – be sure to seat the packs with rubber
handle facing up. Pat down the resin pack by hand to ensure it is
seated properly.
Small Tank Unit (UHP01):
= 1x green Ultra Resin Pack
green
(never use red Ultra Resin Pack
in this unit!)
Large Tank Unit (UHP3C):
= 1x green Ultra Resin Pack (top position)
green
2x red Ultra Resin Packs (middle + bottom position)
red
red
4. REINSTALL TOP CAP ASSEMBLY
• Press down gently, then turn the top cap 1/8 clockwise while steadying
the base unit with your feet.
5. RECONNECT WATERFED POLE TUBING (fig. I)
• Turn "ONˮ water supply at tap (fig. J).
• Inspect system as it pressurizes.
• Keep discharge line open and hold down yellow lever to remove
trapped air from system (fig. K).
6. TEST SYSTEM TDS (fig. L) The value should be at 000.

6. Technical Data

Factor
Weight incl resin
Length x Width x Height
Inner Diameter
Dimension of base
Ultra Resin Packs
Max. permanent pressure (Bar)
Max. water temp. (°F)
Min. water temp. (°F)
10
Resin Change &
Technical Data
UHP01
21 lb.
14.75ˮx13.75ˮx12ˮ
8ˮ
11ˮx12ˮ
1x
max. 8
86˚F
41˚F
www.ungerglobal.com
H
I
J
K
L
UHP3C
71 lb.
27.5ˮx21ˮx42.5ˮ
8ˮ
11ˮx12ˮ
1x , 2x
max. 8
86˚F
41˚F